phototurbidostatv1
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
phototurbidostatv1 [2019/05/22 16:16] botabotadmin [1.3 Setup the MQTT Broker] |
phototurbidostatv1 [2019/08/22 11:04] (current) |
||
|---|---|---|---|
| Line 9: | Line 9: | ||
| * [[:Wi-Fi Turbidimeter V1]] | * [[:Wi-Fi Turbidimeter V1]] | ||
| * [[:Wi-Fi Neopixel light V1]] | * [[:Wi-Fi Neopixel light V1]] | ||
| + | * [[:How to operate]] | ||
| ======Material====== | ======Material====== | ||
| Line 52: | Line 53: | ||
| ---- | ---- | ||
| - | ======Step 1. Prepare your SBC====== | + | ======1. Prepare your SBC====== |
| =====1.1 Install the operating system===== | =====1.1 Install the operating system===== | ||
| Line 142: | Line 143: | ||
| If the Node-Red server is running on the same device as the Mosquitto broker, it is nos necessary to modify the broker IP.\\ | If the Node-Red server is running on the same device as the Mosquitto broker, it is nos necessary to modify the broker IP.\\ | ||
| To modify the broker IP, double clic on the MQTT node (the Pink/Purple ones) and replace **localhost:1883** by **brokerIP:1883**\\ | To modify the broker IP, double clic on the MQTT node (the Pink/Purple ones) and replace **localhost:1883** by **brokerIP:1883**\\ | ||
| - | The broker IP can be obtained by the command **ifconfig** or **hostname -I** | + | The broker IP can be obtained by **ifconfig** or **hostname -I** commands.\\ |
| {{ :mqtt_broker_ip.png?600 |}} | {{ :mqtt_broker_ip.png?600 |}} | ||
| - | ======Step 2. Setup your computer====== | + | ======2. Setup your computer====== |
| - | ======Step 3. ====== | + | __**Work in progress**__ |
| - | + | ======3. 3D Files====== | |
| - | ======Step 4. ====== | + | __**Work in progress**__ |
| - | + | ======4. Arduino Programming====== | |
| - | ======Step 5. ====== | + | __**Work in progress**__ |
| - | + | ======5. Wemos Programming====== | |
| - | ======Step 6. ====== | + | __**Work in progress**__ |
| - | + | ======6. Turbidimeter====== | |
| - | ======Step 7. ====== | + | __**Work in progress**__ |
| - | + | ======7. Lighting system====== | |
| - | ======Step 8. ====== | + | __**Work in progress**__ |
| - | + | ======8. Pumps ====== | |
| - | ======Step 9. ====== | + | __**Work in progress**__ |
| - | + | ======9. Pumps Calibrator ====== | |
| - | ======Step 10. ====== | + | __**Work in progress**__ |
| + | ======10. Power Supply====== | ||
| + | __**Work in progress**__ | ||
phototurbidostatv1.1558534562.txt.gz · Last modified: 2019/08/22 11:04 (external edit)
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
