how_to_operate
This is an old revision of the document!
Table of Contents
How to operate
Installation of the pumps
The first step is to open the pump by unscrewing the four screws placed on the bottom and place the tube between ball bearings as shown below.
Calibration
The first step before using the phototurbidostat is to calibrate the pumps. Each pump needs to be calibrated once. A recalibration is needed when changing the type or the length of the silicone tubing. To calibrate the pumps
how_to_operate.1563549501.txt.gz · Last modified: 2019/08/22 11:04 (external edit)
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
